Supermicro SSE-G24-TG4 - Clear Log Buffer; Clear Log File

Supermicro L2/L3 Switches Configuration Guide
62
LogFile(0 Entries)
1.7.9 Clear Log Buffer
The Syslog buffer can be cleared to enable the fresh logging of messages.
Follow the steps below to clear the logging buffer.
Step Command Description
Step 1
configure terminal
Enters the configuration mode
.
Step 2
clear log buffer
Clear
s the
l
ogging
b
uffer
.
Step 3
e
nd
Exits the configuration mode.
Step 4
show logging
Displays the Syslog configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The example below shows the commands used to clear the logging buffer.
SMIS# configure terminal
SMIS(config)# clear log buffer
SMIS(config)# end
SMIS# show logging
System Log Information
----------------------
Syslog logging: enabled(Number of messages 0)
Console logging: disabled(Number of messages 0)
File logging: disabled(Number of messages 0)
Log File Name:
File Max Entries: 500
TimeStamp option: enabled
Trap logging: Critical
Log server IP: None
Facility: Default (local0)
Buffered size: 50 Entries
LogBuffer(0 Entries)
LogFile(0 Entries)
1.7.10 Clear Log File
The Syslog File can be cleared to enable the fresh logging of messages.