Supermicro SSE-G24-TG4 - Facility

Supermicro L2/L3 Switches Configuration Guide
58
<135> Apr 29 10:11:07 2013:DHC-7:Rcvd Msg 13cb8128 type : 1
<135> Apr 29 10:11:07 2013:DHC-7:Rcvd Event 4
<135> Apr 29 10:11:07 2013:DHC-7:Rcvd Msg 13cf4258 type : 1
<135> Apr 29 10:11:08 2013:DHC-7:Rcvd Event 4
<135> Apr 29 10:11:08 2013:DHC-7:Rcvd Msg 13cf4858 type : 1
LogFile(0 Entries)
1.7.6 Facility
The Syslog Facility provides the approximate details on which part of the system the Syslog message
originated from.
Follow the steps below to configure the Syslog facility.
Step Command Description
Step 1
configure terminal
Enters the configuration mode
.
Step 2
logging facility {local0 | local1 | local2 | lo
cal3 |
local4 | local5 | local6 | local7|}
Configure
s the
Syslog
f
acility.
Step 3
e
nd
Exits the configuration mode.
Step 4
show logging
Displays the
Syslog
configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The
“
no
logging facility
”
command
resets the logging
f
acility to its default value of Local0.
The example below shows the commands used to configure the Syslog facility.
SMIS# configure terminal
SMIS(config)# logging facility local5
SMIS(config)# end
SMIS# show logging
System Log Information
----------------------