Supermicro SSE-G24-TG4 - Management IP Address - DHCP Configuration; Default IP Gateway

Supermicro L2/L3 Switches Configuration Guide
8
1.1.2 Management IP Address – DHCP Configuration
Supermicro switches can be configured to obtain the management IP address through the DHCP
protocol. In this case, a switch acts as a DHCP client and obtains the IP address for any DHCP server on
the LAN.
Follow the steps below to obtain the management interface IP address dynamically from a DHCP server.
Step Command Description
Step 1
configure terminal
Enters the configuration mode
.
Step 2
ip address dhcp
Configures the management interface
IP address through the DHCP server.
Step 3
end
Exits the
configuration mode.
Step 4
show ip interface
Displays the
m
anagement interface IP
configuration.
The
IP address dhcp
configuration is saved automatically as part of
the
start
-
up
configuration.
The “no ip address dhcp” command disables the configuring of the management interface
IP address through the DHCP server.
The example below shows the commands used to configure the management interface IP address
through DHCP.
SMIS# configure terminal
SMIS(config)#ip address dhcp
SMIS(config)# end
1.1.3 Default IP Gateway
To configure the default gateway IP address in blade switches, follow the steps below.
Step Command Description
Step 1
configure terminal
Enters the configuration mode
.
Step 2
ip gateway <ip
-
address>
Configure
s
the
IP gateway
address
.
ip-address – IP address of a directly
connected router.
Step 3
end
Exits the configuration mode.
Step 4
show ip interface
Displays the interface IP configuration.