Supermicro SSE-G24-TG4 - Page 57

Supermicro L2/L3 Switches Configuration Guide
57
maximum size of 200 entries
.
Step 3
e
nd
Exits the configuration mode.
Step 4
show logging
Displays the
Syslog
configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The
“
no
logging buffered
”
command
resets the Logging buffer to its default value of 50
entries.
The example below shows the commands used to configure the Syslog buffer.
SMIS# configure terminal
SMIS(config)# logging buffered 200
SMIS(config)# end
SMIS# show logging
System Log Information
----------------------
Syslog logging: enabled(Number of messages 0)
Console logging: disabled(Number of messages 0)
File logging: disabled(Number of messages 0)
Log File Name:
File Max Entries: 500
TimeStamp option: enabled
Trap logging: Critical
Log server IP: None
Facility: Default (local0)
Buffered size: 200 Entries
LogBuffer(11 Entries)
<135> Apr 29 10:11:05 2013:DHC-7:Exitting DHCPC Task Init
<135> Apr 29 10:11:05 2013:DHC-7:Entered in DhcpCIntSelectTaskMain fn
<135> Apr 29 10:11:05 2013:DHC-7:Entered in DhcpCSocketOpen fn
<135> Apr 29 10:11:07 2013:DHC-7:Rcvd Event 4
<135> Apr 29 10:11:07 2013:DHC-7:Rcvd Msg 13cb8128 type : 1
<135> Apr 29 10:11:07 2013:DHC-7:Rcvd Event 4