Supermicro SSE-G24-TG4 - Page 23

Supermicro L2/L3 Switches Configuration Guide
23
between the start and end interface
numbers. E.g.: int range gi 0/1-10
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range gi 0/1-10, gi 0/20
If multiple interfaces are provided, the
next step will perform the particular
configuration on all these interfaces.
Step 3
speed { 10 | 100 | 1000 | 10000 }
Configure
the i
nterface
s
peed as 10
,
100, 1000 or 10000 Mbps.
Step 4
end
Exits the configuration mode.
Step 5
show interface status
Displays the interface configuration.
Step 6
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The
“no speed”
command
restores the default interface speed.
The example below shows the commands used to configure the interface speed.
SMIS# configure terminal
SMIS(config)# interface Gi 0/22
SMIS(config-if)# speed 10
SMIS(config-if)# end
SMIS# show interface status
Port Status Duplex Speed Negotiation
---- ------ ------ ----- -----------
Gi0/1 not connected Full 1 Gbps Auto
Gi0/2 not connected Full 1 Gbps Auto
Gi0/3 not connected Full 1 Gbps Auto
Gi0/4 not connected Full 1 Gbps Auto
Gi0/5 not connected Full 1 Gbps Auto