Supermicro SSE-G24-TG4 - Page 41

Supermicro L2/L3 Switches Configuration Guide
41
String
–
Contact information entered as
a String of maximum length 256.
Step 3
end
Exits the configuration mode.
Step 4
show system information
Displays the
s
ystem information
configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
T
he
System Contact
configuration is automatically stored as part of
the
startup
-
configuration file.
The example below shows the commands used to configure a switch contact.
SMIS# configure terminal
SMIS(config)# system contact "User1 at CA”
SMIS(config)# end
SMIS# show system information
Switch Name: SMIS
Switch Base MAC Address: 00:30:48:e3:70:bc
SNMP EngineID: 80.00.08.1c.04.46.53
System Contact: User1 at CA
System Location: Supermicro
Logging Option: Console Logging
Login Authentication Mode: Local
Snoop Forward Mode: MAC based
Config Restore Status: Not Initiated
Config Restore Option: No restore
Config Restore Filename: iss.conf
Config Save IP Address: 0.0.0.0
Device Up Time: 0 days 0 hrs 50 mins 51 secs
Boot-up Flash Area: Normal
NTP Broadcast Mode: No
[NTP] ntp is disabled
Server Key Prefer
=============== ===== ======
Key # Key
======= ====================================