Supermicro SSE-G24-TG4 - Page 85

Supermicro L2/L3 Switches Configuration Guide
85
Resetting to
the
factory defaults will remove all the stored configurations,
the
files
in
the
flash memory, user accounts and management IP address.
After resetting to factory defaults, a switch can be managed using the default management
IP address 192.168.100.102 with the default administrator user name ADMIN and password
ADMIN.
The example below shows the command to reset to the factory defaults.
SMIS(config)# reset-to-factory-defaults
This command will reset settings to the factory defaults.
After resetting to the factory defaults, a switch will be reloaded immediately.
Do you really want to execute this command and reload the switch? [y/n]