Supermicro SuperServer 1029GQ-TRT - Installing the Inner Rails on the Chassis

Chapter 2: Server Installation
25
Figure 2-3. Installing the Inner Rails
Installing The Inner Rails on the Chassis
Installing the Inner Rails
1. Identify the left and right inner rails.
2. 
side of the chassis with the slotted holes in the inner rail.
3. Slide the inner rail toward the rear of the chassis and under the T-studs. A spring clip
will snap onto one of the T-studs when it is in place.
4. An optional (M4) screw can be used to secure the rail to the chassis.
Warning: Do not pick up the server by the front handles. They are designed to pull
the system from a rack only.
4
3
2
MCP-290-11809-0N
Press
* Original setting
* Round cylinder
674 mm to 1048 mm
3
Note󰀨