Supermicro SuperServer 1029GQ-TRT - Control Panel

58
SuperServer 1029GQ-T(N/X/V)RT User's Manual
Control Panel


All JF1 wires have been bundled into a single cable to simplify this connection. Make sure
the red wire plugs into pin 1 as marked on the motherboard. The other end connects to the
control panel PCB board.
Power Button
UID LED
NIC1 Active LED
Reset Button
HDD LED
PWR LED
Reset
PWR
3.3V Stby
3.3V Stby
Ground
19
X
Ground
X
3.3V Stby
20
1 2
Ground
Power Fail LED
NIC2 Active LED
NMI
3.3V
3.3V
OH/Fan Fail LED
Figure 4-1. JF1: Control Panel Pins
Power Button
The Power Button connection is located on pins 1 and 2 of JF1. Momentarily contacting both
󰀨
󰀨
is in suspend mode, press the button for 4 seconds or longer.
Power Button
PinDenitions(JF1)
Pin# Denition
1 Signal
2 Ground