Supermicro SuperServer 1029GQ-TRT - Page 76

SuperServer 1029GQ-T(N/X/V)RT User's Manual
76
Turbo Mode
This feature will enable dynamic control of the processor, allowing it to run above stock
frequency. The options are Disable and Enable.
Hardware PM State Control
Hardware P-States
If this feature is set to Disable, hardware will choose a P-state setting for the system based
on an OS request. If this feature is set to Native Mode, hardware will choose a P-state setting
based on OS guidance. If this feature is set to Native Mode with No Legacy Support, hardware
will choose a P-state setting independently without OS guidance. The options are Disable,
Native Mode, Out of Band Mode, and Native Mode with No Legacy Support.
CPU C State Control
Autonomous Core C-State
Select Enable to support Autonomous Core C-State control which will allow the processor
core to control its C-State setting automatically and independently. The options are Enable
and Disable.
CPU C6 Report
Select Enabled to allow the BIOS to report the CPU C6 State (ACPI C3) to the operating
             󰀨   
Disable , Enable, and Auto.
Enhanced Halt State (C1E)
          
CPU's power consumption by reducing the CPU's clock cycle and voltage during a Halt-state.
The options are Disable and Enable.
Package C State Control
Package C State
This feature allows the user to set the limit on the C State package register. The options are
C0/C1 State, C2 State, C6 (Non Retention) State, C6 (Retention) state, No Limit, and Auto..
ChipsetConguration
Warning: Setting the wrong values in the following features may cause the system to malfunc-
tion.
North Bridge
