Supermicro SuperServer 1029GQ-TRT - Page 78

SuperServer 1029GQ-T(N/X/V)RT User's Manual
78
MemoryConguration
Enforce POR
Select Enable to enforce POR restrictions on DDR4 frequency and voltage programming.
The options are Enabled and Disable.
Memory Frequency
Use this feature to set the maximum memory frequency for onboard memory modules.
The options are Auto, 1333, 1400, 1600, 1800, 1867, 2000, 2133, 2200, and 2400.
Data Scrambling for NVDIMM
Use this festure to enable or disable data scrambling for non-volatile DIMM (NVDIMM)
memory. The options are Auto, Disable, and Enable.
Data Scrambling for DDR4
Use this feature to enable or disable data scrambling for DDR4 memory. The options
are Auto, Disable, and Enable.
tCCD_L Relaxation
If Enabled, the tCCD_L overrides the SPD. When disabled, it is enforced based on
memory frequency. The options are Enable and Disable.
Enable ADR
Select Enable for ADR (Automatic Diagnostic Repository) support to enhance memory
performance. The options are Disable and Enable.
Memory Topology
This feature displays DIMM population information.
MemoryRASConguration
Static Virtual Lockstep Mode
Select Enable to run the system's memory channels in lockstep mode to minimize memory
access latency. The options are Disable and Enable.
Mirror Mode
Select Enable to set all 1LM/2LM memory installed in the system on the mirror mode,
which will create a duplicate copy of data stored in the memory to increase memory
security, but it will reduce the memory capacity into half. The options are Enable and
Disable.
Memory Rank Sparing
Select Enable to enable memory-sparing support for memory ranks to improve memory
performance. The options are Disable and Enable.