Supermicro SuperServer 1029GQ-TRT - Page 99

Chapter 6: BIOS
99
When SEL is Full
This feature allows the user to decide what the BIOS should do when the system event log
is full. Select Erase Immediately to erase all events in the log when the system event log is
full. The options are Do Nothing and Erase Immediately.
Custom EFI Logging Options
Log EFI Status Codes
This feature allows the user to determine whether the BIOS will log EFI Status Cods, error
code only, progress code only, or both. The optioins are Disabled, Both, Error code, and
Progress code
Note: After making changes on a setting, be sure to reboot the system for the changes
󰀨
BMCNetworkConguration
CongureIPV4support
IPMI LAN Selection
This item displays the IPMI LAN setting. The default setting is Failover.
IPMI Network Link Status
This item displays the IPMI Network Link status. The default setting is Dedicated LAN.
CurrentCongurationAddresssource
This feature allows the user to select the source of the IP address for this computer. If Static
is selected, you will need to know the IP address of this computer and enter it to the system


IP address for this computer. The options are DHCP and Static.
Station IP Address
This item displays the Station IP address for this computer. This should be in decimal and in
dotted quad form (i.e., 192.168.10.253).
Subnet Mask
This item displays the sub-network that this computer belongs to. The value of each three-
digit number separated by dots should not exceed 255.
Station MAC Address
This item displays the Station MAC address for this computer. Mac addresses are 6 two-digit
hexadecimal numbers.