Chapter 7: AMI BIOS
7-5
Bootup Num-Lock
Use this feature to set the Power-on state for the <Numlock> key. The options
On.
Wait For 'F1' If Error
Use this feature to force the system to wait until the 'F1' key is pressed if an error
occurs. The options are Disabled and Enabled.
Interrupt 19 Capture
Interrupt 19 is the software interrupt that handles the boot disk function. When this
item is set to Enabled, the ROM BIOS of the host adaptors will "capture" Interrupt
19 at bootup and allow the drives that are attached to these host adaptors to func-
tion as bootable disks. If this item is set to Disabled, the ROM BIOS of the host
adaptors will not capture Interrupt 19, and the drives attached to these adaptors
will not function as bootable devices. The options are Immediately and Postponed.
Power Conguration
Watch Dog Function
If enabled, the Watch Dog Timer will allow the system to reset or generate NMI
based on jumper settings when it is expired for more than 5 minutes. The options
are Enabled and Disabled.
Power Button Function
This feature controls how the system shuts down when the power button is pressed.
are 4 Seconds Override and Instant O.
Restore on AC Power Loss
power to be turned on after a power loss. Select Last State to allow the system
to resume its last power state before a power loss. The options are Power-On,
and Last State.
WOL (Wake-On LAN) Support
Select Enabled to enable WOL support which will allow the system to "wake-up"
when a device connected to a LAN port receives a signal. The options are Dis-
abled and Enabled.
To Next Page
Loading...
