46
SuperServer E300-8D User's Manual
Starting the Setup Utility
Normally, the only visible Power-On Self-Test (POST) routine is the memory test. As the
memory is being tested, press the <Delete> key to enter the main menu of the AMI BIOS
setup utility. From the main menu, you can access the other setup screens. An AMI BIOS
message.
Caution: Do not upgrade the BIOS unless your system has a BIOS-related issue. Flashing the
wrong BIOS can cause irreparable damage to the system. In no event shall the manufacturer
be liable for direct, indirect, special, incidental, or consequential damage arising from a BIOS
update. If you have to update the BIOS, do not shut down or reset the system while the BIOS
is being updated to avoid possible boot failure.
5-2 Main Page
always return to the Main setup screen by selecting the Main tab on the top of the screen.
The Main BIOS Setup screen is shown below.
The following Main menu items are displayed:
To Next Page
Loading...
