Supermicro SuperServer E300-8D - Page 60

60
SuperServer E300-8D User's Manual
*If the item "Congure SATA as" is set to IDE, the following items will display:
SATA Frozen
Use this item to enable the HDD Security Frozen Mode. The options are Disabled and
Enabled.
Port 0 ~ Port 5 SATA Device Type (Available when a SATA port is detected)

State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
Server ME (Management Engine) Conguration

• 
• Operational Firmware Version
• ME Firmware Type
• Recovery Firmware Version
• ME Firmware Features
• ME Firmware Status #1
• ME Firmware Status #2
• Current State
• Error Code
PCIe/PCI/PnP Conguration
The following information will display:
• PCI Bus Driver Version
• PCI Devices Common Settings:
PCI PERR/SERR Support
Select Enabled to allow a PCI device to generate a PERR/SERR number for a PCI Bus Signal
Error Event. The options are Enabled and Disabled.
Above 4G Decoding (Available if the system supports 64-bit PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G Address.
The options are Disabled and Enabled.