Supermicro SuperServer SYS-110P-FRN2T - PCI Expansion Cards; Installing PCI Expansion Cards

45
Chapter 3: Maintenance and Component Installation
3.7 PCI Expansion Cards
The system includes a pre-installed riser card that positions one or two full-height, PCIe x16

Installing PCI Expansion Cards
1. Remove power as described in Section 3.1 and remove the chassis cover.
2. 
3. Hold the bracket corner with one hand and the plastic handle with another. Lift the
bracket vertically.
Warning: Do not tilt or wiggle the riser bracket when lifting it up.
Figure 3-6. Removing the Riser Card Bracket
Expansion Card
Slot Shield
Three Screws
Two Screws
Plastic Handle
Bracket Corner