56
Chapter 3: Maintenance and Component Installation
3.11 Cable Routing Diagram
Refer to the diagram below for a representation of how the main cables are routed throughout
the system. When disconnecting cables to add or replace components, refer to this diagram
when adding or replacing components so you can reroute them in the same manner. Proper
Online Cable Matrix
Fan Cable
CBL-OTHR-1214-24
SATA Cable
CBL-0483L
Figure 3-16. Cable Routing Diagram
3.10 BMC
The BMC can be reset using the button on the front control panel or on the chassis rear.
• Reset—Press and hold the button. After six seconds, the LED blinks at 2Hz. The BMC
resets and the reset duration is ~250ms. Then the BMC starts to boot.
•
• -
ing the update.
BMC Reset Options
Event LED
Reset Blinks at 2Hz
Restore
Defaults
Blinks at 4Hz
Update Blinks at 10Hz
To Next Page
Loading...
