Supermicro SuperServer SYS-110P-FRN2T - Page 54

54
Chapter 3: Maintenance and Component Installation
Replacing the Power Supply (110P-FRDN2T)
1. 
2. Check the power supply's LED.
Power Supply LED States
LED Color Denition
󰀨 No power input
Amber 󰀨
Green
Power supply is on and
operating
Figure 3-14. DC Power Supply Rear View
LED
3. Disconnect the power supply from the external power source.
4. Push the release button towards the handle.
5. Using the handle, pull the power supply out of the chassis.
6. Slide the new power supply into the chassis until it clicks into place.
7. Reconnect the power supply to the external power source.
8. Check the power supply's LED.
9. Use remote management to check the power supply status.