SuperStorage 2029P-E1CR48H/L User's Manual
156
Option #1 as shown below. Then, set Boot Option #1 to [UEFI AP:UEFI: Built-in EFI
Shell]. Press <F4> to save the settings and exit the BIOS Setup utility.
8. When the UEFI Shell prompt appears, type fs# to change the device directory path. Go
to the directory that contains the BIOS package you extracted earlier from Step 6. Enter
Note: Do not interrupt this process
7. Press <Del> continuously during system boot to enter the BIOS Setup utility. From the
top of the tool bar, select Boot to enter the submenu. From the submenu list, select Boot
To Next Page
Loading...
