Chapter 4: AMI BIOS
4-21
• ME Firmware Status #1
• ME Firmware Status #2
• Current State
• Error Code
PCIe/PCI/PnP Conguration
The following PCI information will be displayed:
• PCI Bus Driver Version
• PCI Devices Common Settings:
PCI Latency Timer
Use this feature to set the latency timer for each PCI device installed on a PCI bus.
Select 32 to set the PCI latency to 32. The options are 32, 64, 96, 128, 160, 192,
224 and 248 PCI Bus Clocks.
PCI-X Latency Timer
Use this feature to set the latency timer for each PCI device installed on a PCI bus.
Select 64 to set the PCI latency to 64. The options are 32, 64, 96, 128, 160, 192,
224 and 248 PCI Bus Clocks.
PERR# Generation
Select Enabled to allow a PCI device to generate a PERR (PCI/PCI-E Parity Error)
number for a PCI bus error event. The options are Enabled and Disabled.
SERR# Generation
Select Enabled to allow a PCI device to generate an SERR (System Error) number
for a PCI bus error event. The options are Enabled and Disabled.
PCI PERR/SERR Support
Use this feature to enable or disable the runtime event for PCI errors. The options
are Disabled and Enabled.
Above 4G Decoding (Available if the system supports 64-bit PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G
Address. The options are Enabled and Disabled.
To Next Page
Loading...
