Supermicro X10SRM-F - Page 61

61
Chapter 2: Installation
IPMI_LAN
USB0/1
LAN1
LAN2
USB6/7
(3.0)
JPL1
JSTBY1
JPG1
JTPM1
COM2
COM1
FAN4
JF1
JPH1
JPV1
JPW1
FAN1
JPI2C1
FAN2
FAN3
FANA
JPUSB1
USB10 (3.0)
USB8/9 (3.0)
USB4/5
I-SGPIO2
I-SGPIO1
JS1
JL1
USB2/3
JP3
JWD1
JPME2
JI2C2
JI2C1
JPB1
JBT1
BT1
JMD1
JNVI2C1
JIPMB1
LEDBMC
LEDPWR
LE8
LE1
JUIDB1
VGA
JPCIE4 JPCIE5
JPCIE6
CPU1 SLOT6 PCI-E 3.0 X16
CPU1 SLOT5 PCI-E 3.0 X8
CPU1 SLOT4 PCI-E 3.0 X8
FAN5
I-SATA3
SP1
I-SATA2
I-SATA1
I-SATA0
I-SATA5
I-SATA4
JSD2
JSD1
JPH2
DIMMA1 DIMMB1
DIMMD1 DIMMC1
CLOSE 1st
OPEN 1st
MAC CODE
BAR CODE BAR CODE
CPU
INTEL PCH
LAN
CONTROLLER
X10SRM-F/-TF
REV:1.01
Designed in the USA
SRW5
SRW4
SRW3
JVRM2 JVRM1
JOH1
JD1
USB Wake-up
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled
Pins 2-3 Disabled
1. USB Wake-up
2. Manufacture Mode
1
2
USB Wake-Up
Use the JPUSB1 jumper to enable the function of "System Waking-Up via USB devices" for
USB4/5 and USB10/11. This jumper allows you to "wake-up" the system by pressing a key on
the USB keyboard or by clicking the USB mouse of your system. The JPUSB1 jumper is used
together with the USB Wake-Up function in the BIOS. Enable both the jumper and the BIOS
setting to enable this function. See the table on the right for jumper settings and connections.
Manufacture Mode Select
Close pins 2 and 3 of jumper JPME2 to bypass SPI ash security and force the system to
operate in the manufacturer mode, which will allow the user to ash the system rmware from
a host server for system setting modications. Refer to the table below for jumper settings.
The default setting is Normal.
Manufacture Mode
Jumper Settings
Jumper Setting Denition
Pins 1-2 Normal
Pins 2-3 Manufacture Mode