Supermicro X11SPM-F - Page 44

44
Super X11SPM-F/-TF/-TPF User's Manual
Power Button
UID LED
NIC1 Active LED
Reset Button
HDD LED
PWR LED
Reset
PWR
3.3V
UID Switch
3.3V Stby
Ground
19
X
Ground
X
3.3V Stby
20
1 2
Ground
Power Fail LED
NIC2 Active LED
NMI
OH/Fan Fail LED
3.3V
1
2
1. UID LED
2. OH/FAN Fail LED
Overheat (OH)/Fan Fail
Connect an LED cable to pins 7 and 8 of the Front Control Panel to use the Overheat/Fan
Fail LED connections. The LED on pin 8 provides warnings of overheat or fan failure. Refer
to the tables below for pin denitions.
OH/Fan Fail Indicator
Status
State Denition
Off Normal
On Overheat
Flashing Fan Fail
OH/Fan Fail LED
Pin Denitions (JF1)
Pin# Denition
7 OH/Fan Fail LED Anode
8 OH/Fan Fail LED Cathode
UID LED
The UID LED is on pins 7 and 8 of JF1. Connect a cable here to show the UID activity. Refer
to the table below for pin denitions.
UID LED
Pin Denitions (JF1)
Pins Denition
7 UID LED Cathode
8 UID LED Anode