Supermicro X11SPM-F - Page 60

60
Super X11SPM-F/-TF/-TPF User's Manual
+
PCB EDGE
PRESS FIT
1
1
DESIGNED IN USA
MAC CODE
X11SPM-F/-TF/-TPF
REV: 1.01
BAR CODE
Intel
PCH
JPV1
BT1
S-SGPIO1
S-SATA0
S-SATA1
S-SATA3
S-SATA2
JPH1
J18
COM2
JTPM1
JSTBY1
UID_LED1
LEDPWR
JIPMB1
JNVI2C1
JD1
JF1
JPI2C1
BMC_HB_LED1
LEDT2
LEDT1
LEDT3
LEDT4
JUIDB1
FANB
FAN5
FAN6
FAN2
FAN1
FAN4
FANA
FAN3
JPW1
SRW4
SRW3
JMD1
JSD1
JSD2
JRK1
JL1
JBT1
JPME2
JPUSB1
JWD1
JPG1
JPME1
COM1
VGA
LAN1/2
(-TF)
USB6/7
(3.0)
IPMI_LAN
USB0/1
JF1
NMI
X
LED
NIC1
X
LED
HDD
PWR
NIC2
OH/
FF
RST
ON
PWR
CPU1 SLOT7 PCI-E 3.0 X8
CPU1 SLOT6 PCI-E 3.0 X16
CPU
USB8/9(3.0)
USB10(3.0)
I-SATA4-7
I-SATA0-3
USB4/5
USB2/3
CPU1 SLOT4 PCI-E 3.0 X16
LAN1/2
(-F/-TPF)
DIMMC1 DIMMB1 DIMMA1
DIMMF1 DIMME1 DIMMD1
ASpeed
AST2500
Intel
X557
(-TF)
Inphi
CS4227
(-TPF)
Marvell
88E1512
(-F)
1
1. ME Recovery
2. ME Manufacturing
2
ME Recovery
Use jumper JPME1 to select ME Firmware Recovery Mode, which will limit resource
allocation for essential system operation only in order to maintain normal power operation and
management. In the single operation, online upgrade will be available via Recovery mode.
Refer to the table below for jumper settings.
ME Recovery
Jumper Settings
Jumper Setting Denition
Pins 1-2 Normal
Pins 2-3 ME Recovery
ME Manufacturing Mode
Close pins 2-3 of jumper JPME2 to bypass SPI ash security and force the system to operate
in the manufacturing mode, which will allow the user to ash the system rmware from a
host server for system setting modications. Refer to the table below for jumper settings.
The default setting is Normal.
Manufacturing Mode
Jumper Settings
Jumper Setting Denition
Pins 1-2 Normal
Pins 2-3 Manufacturing Mode