Supermicro X13SCL-IF - Page 25

25
Chapter 2: Installation
4. Apply the proper amount of thermal grease on the CPU.
5. Place the heatsink on top of the CPU so that the four mounting holes on the heatsink
are aligned with those on the retention mechanism.
6. With a T30 bit torque driver set to a force of 8.0 in-lbf (0.904 N-m), tighten the screws.
3
4
5
6
7
8
9
1
0
1
1
IN-LBF
8.0
0.904
N-M
Screw
Screw
Screw
Motherboard
top side