Supermicro X13SCL-IF - 2.3 Motherboard Installation

27
Chapter 2: Installation
2.3 Motherboard Installation
All motherboards have standard mounting holes to t di󰀨erent types of chassis. Make sure
that the locations of all the mounting holes for both the motherboard and the chassis match.
Although a chassis may have both plastic and metal mounting fasteners, metal ones are
highly recommended because they ground the motherboard to the chassis. Make sure that
the metal stando󰀨s click in or are screwed in tightly.
Location of Mounting Holes
Note 1: Do not use a force greater than 8 in-lbf (0.904 N-m) on each mounting screw
during motherboard installation. Exceeding this force may over-torque the screw, caus-
ing damage to the motherboard and screw.
Note 2: Some components are very close to the mounting holes. Take precautionary
measures to avoid damaging these components when installing the motherboard to
the chassis.
8
9
1
0
1
1
1
2
1
3
1
4
Torque Driver
(1)
Stando󰀨s (4)
Only if Needed
Phillips Screws
(4)
Tools Needed
DESIGNED IN USA
X13SCL-IF
REV:1.01
BAR CODE
BIOS LICENSE
JL1
JSMB1
JTPM1
I-SATA4
I-SATA5
BT1
JSLIM2
JSLIM1
C262
JPCIE1
JCPLD1
JD1
LED3
LEDM1
JPI2C1
JMD1_SRW1
JPW2
FANA
FAN3
FAN2
FAN1
JF1
JPW1
JMD1
JBT1
JPME2
JNS1
JRF1
JPL1
JPL2
JWD1
JPG1
JVRM1
MH4
MH3
MH2
MH1
JUIDB1
LED1
LED2
PCIe 4.0 x4
PCIe 4.0 x4 / SATA x4
CMOS CLEAR
2-3: NVMe
1-2: SATAJNS1:
LEDPWR
LEDBMC
USB4/5 (3.2(5Gb))
USB2/3 (3.2(5Gb))
COM1
PCIe 4.0 x4
JMD1:M.2-C
VGA
LAN1/2
JL1: CHASSIS INTRUSION
BMC_LAN
USB0/1
:SMBus1
:PWR I2C
1-4:SPEAKER
1-2:ENABLE
2-3:DISABLE
JPL2:LAN2
2-3:DISABLE
1-2:ENABLE
JPL1:LAN1
ON
PWR
RST
JF1:
NIC2
FF OH
X
NIC1
LED PWR
LED HDD
CPU SLOT7 PCIe 5.0 x16 (IN x16)
DIMMA1
DIMMB1
2-3:ME MANUFACTURING MODE
JWD1:WATCH DOG
1-2:RST
2-3:NMI
1-2:ENABLE
2-3:DISABLE
JPG1:VGA
JPME2:
1-2:NORMAL
CPU
JTPM1:TPM/PORT80
BMC
Controller