Supermicro X13SCL-IF - Page 81

Chapter 4: UEFI BIOS
81
Serial Port for Out-Of-Band Management/Windows Emergency Management Services
(EMS)
Console Redirection EMS
Select Enabled to use a COM port EMS Console Redirection. The options are Disabled
and Enabled.
Console Redirection Settings
Out-of-Band Mgmt Port
This feature selects a serial port in a client server to be used by the Microsoft Windows
Emergency Management Services (EMS) to communicate with a remote host server.
The options are COM1 and SOL.
Terminal Type EMS
Use this feature to select the target terminal emulation type for Console Redirection.
Select VT100 to use the ASCII character set. Select VT100+ to add color and function
key support. Select ANSI to use the extended ASCII character set. Select VT-UTF8 to
use UTF8 encoding to map Unicode characters into one or more bytes. The options are
VT100, VT100Plus, VT-UTF8, and ANSI.
Bits Per Second EMS
This feature sets the transmission speed for a serial port used in Console Redirection.
Make sure that the same speed is used in the host computer and the client computer.
A lower transmission speed may be required for long and busy lines. The options are
9600, 19200, 57600, and 115200 (bits per second).
Flow Control EMS
Use this feature to set the ow control for Console Redirection to prevent data loss caused
by bu󰀨er overow. Send a "Stop" signal to stop sending data when the receiving bu󰀨er
is full. Send a "Start" signal to start sending data when the receiving bu󰀨er is empty. The
options are None, Hardware RTS/CTS, and Software Xon/Xo󰀨.
The setting for each of these features is displayed:
• Data Bits EMS
• Parity EMS
• Stop Bits EMS