Supermicro X13SCL-IF - Page 84

Super X13SCL-IF User's Manual
84
USB Mass Storage Driver Support
This feature enables USB mass storage driver support. The options are Disabled and Enabled.
Mass Storage Devices:
STT USB_RM2M 1100
Select Auto to enumerate devices according to their media format. The options are Auto,
Floppy, Forced FDD, Hard Disk, and CD-ROM.
PCIe/PCI/PnP Conguration
PCI Devices Common Settings:
SR-IOV Support
Use this feature to enable or disable Single Root IO Virtualization Support. The options are
Disabled and Enabled.
BME DMA Mitigation
Enable this feature to help block DMA attacks. The options are Disabled and Enabled.
Onboard Video Option ROM
Use this feature to select the Onboard Video Option ROM type. The options are Disabled
and EFI.
Above 4GB MMIO BIOS Assignment
Select Enable for remapping of BIOS above 4GB. The options are Enabled and Disabled.
PCI PERR/SERR Support
Select Enabled to allow a PCI device to generate a PERR/SERR number for a PCI Bus Signal
Error Event. The options are Disabled and Enabled.
VGA Priority
Use this feature to select the graphics device to be used as the primary video display for
system boot. The options are Onboard and O󰀨board.
NVMe Firmware Source
Use this feature to select the NVMe rmware to support booting. The options are Vendor
Dened Firmware and AMI Native Support. The default option, Vendor Dened Firmware,
is pre-installed on the drive and may resolve errata or enable innovative functions for the
drive. The other option, AMI Native Support, is o󰀨ered by the BIOS with a generic method.
Storage Option ROM/UEFI Driver
Use this feature to enable device name support for onboard devices and slots. The options
are Do not Launch, UEFI, and Legacy.