Chapter 4: AMI BIOS
4-11
Pass Gate Stress Test Conguration
Pass Gate Test
Select Enabled to use the Pass Gate test. The options are Disabled and En-
abled.
Pass Gate Test Direction
This feature species how the BIOS setup utility should perform the Pass Gate
test (from the lowest memory to the highest or from the highest memory to the
lowest.) The options are Lowest to Highest and Highest to Lowest.
Pass Gate Test Repetition
Use this feature to specify how many times the Pass Gate test should be per-
formed over the same memory row (x1000). The default setting is 900.
Pass Gate Test Iterations
Use this feature to specify how many repetitions the Pass Gate test should be
performed over the same memory row (refer to the item above). The default
setting is 1.
Pass Gate Test Swizzle (For Samsung Products)
Select Enabled to use the Pass Gate Test Swizzle mode to support Samsung
products. Select Auto for the system to automatically switch to the Pass Gate
Test Swizzle mode when a Samsung device is detected. The options are Auto
and Enabled.
Pass Gate Pattern
Use the keyboard to enter the parameter value of the Pass Gate Pattern used
for data input. The options are 0's and 1's.
Pass Gate Target Pattern
Use the keyboard to enter the target parameter value for the Pass Gate Pattern
used for data input. The options are 0's and 1's.
Pass Gate Speed
Use this feature to set the Pass Gate speed. The options are Auto and 1x Only.
Channel 0/Channel 1
Rank 0/Rank 1/Rank 2/Rank 3
Select Enabled to allow the Pass Gate test to be performed on a memory module
specied by the user. The options are Enabled and Disabled.
To Next Page
Loading...
Need help?
General
