Supero X10SLQ - Rebooting System via Jumper JBR1

D-2
X10SLQ/X10SLQ-L User’s Manual
D-2 Steps to Reboot the System by Using Jumper
JBR1
1. Power down the system.
2. Close pins 2-3 on Jumper JBR1, and power on the system.
3. Follow the BIOS recovery SOP listed in the previous chapter (Appendix C).
4. After completing the steps above, power down the system.
5. Close pins 1-2 on Jumper JBR1, and power on the system.