Chapter 4: AMI BIOS
4-13
Gfx (Graphics) Low Power Mode
Select Enabled to use the low power mode for internal graphics devices installed
in a small form factor (SFF) computer. The options are Enabled and Disabled.Gfx
(Graphics) Low Power Mode
PCI-E Conguration
This item displays the information of the (graphics) device installed on a PCI-E
slot.
•Slot7 PCI-E 3.0 x16
Slot7 PCI-E 3.0 x16 Gen X
This feature allows the user to select PCI-E support for the device installed on
Slot7. The options are Auto, Gen1 (Generation 1), Gen 2 and Gen 3.
Detect Non-Compliance Device
Select Enabled for the AMI BIOS to automatically detect a PCI-E device that is
not compliant with the PCI-E standards. The options are Enabled and Disabled.
Program PCI-E ASPM After OpROM
PCI-E ASPM, the Active State Power Management for PCI-Express slots, is a
power management protocol used to manage power consumption of serial-link
devices installed on PCI-Exp slots during a prolonged off-peak time. If this item
is set to Enabled, PCI-E ASMP will be programmed after OpROM. If this item
is set to Disabled, the PCI-E ASPM will be programmed before OpROM. The
options are Enabled and Disabled.
Slot7 PCI-E 3.0 x 16 ASPM/Slot5 PCI-E 2.0 x1 ASPM/Slot4 PCI-E 2.0 x4
ASPM
Use this feature to set the ASPM (Active State Power Management) level for the
graphics device installed on a PCI-E slot specied by the user. The options are
Disabled, Auto, ASPM L0s, ASPM L1, and, ASPM L0sL1.
Memory Conguration
This item displays the following information on the memory modules installed
on the motherboard.
•Memory RC Version
•Memory Frequency
•Total Memory
To Next Page
Loading...
Need help?
General
