Supero X10SLQ - Advanced Setup: Hardware Monitor, Fan Control

Chapter 4: AMI BIOS
4-23
Transmit Mode (Available for Serial Port2 via Chip NCT6776F only)
Use this feature to select data transmission mode for a serial port specied.
The options are RS232 Mode, RS485 Mode, and RS422 Mode.

H/W (Hardware) Monitor
PC Health Status
Fan Speed Control Mode
This feature allows the user to decide how the system controls the speeds of the
onboard fans. The CPU temperature and the fan speed are correlative. When the
CPU on-die temperature increases, the fan speed will also increase for effective
system cooling. Select "Full Speed" to allow the onboard fans to run at full speed
(of 100% Pulse Width Modulation Duty Cycle) for maximum cooling. This setting
is recommended for special system conguration or debugging. Select "Standard"
for the onboard fans to run at 50% of the Initial PWM Cycle in order to balance the
needs between system cooling and power saving. This setting is recommended for
regular systems with normal hardware congurations. The options are Full Speed
(@100% of PWM Cycle) and Standard (@50% of PWM Cycle).
The following items will be displayed:
•CPU Temperature (PECI)
•System Temperature
•Peripheral Temperature
•PCH Temperature
•Fan 1 Speed/Fan 2 Speed/Fan 3 Speed/Fan 4 Speed
•VCORE
•12V
•VDIMM
•5Vcc
•PCH 1.05V
•AVCC
• 3.3Vcc