SureCall Flare 3.0 | Installation
English
12
1-888-365-6283 | support@surecall.com | www.surecall.com
INSTALLATION
Before installation, review all the information in this manual.
Prior to securing the location of any booster parts, a “soft install” is recommended as adjustments may be needed to
optimize performance.
Installation Overview
Step 1. Find the outside area with the strongest signal.
Step 2. Install the outside antenna , connect coax cable and route the cable indoors.
Step 3. Place the Flare 3.0 on a table or desktop, center of the area where signal is needed and connect to cable.
Step 4. Connect the Flare booster to the provided power cable and plug into an AC power source.
Check system and optimize installation, if needed
➌
➍
➊
➋
Maximize vertical antenna separation
– 25 ft minimum
Identify the outside location with the strongest signal
for placement of your outdoor antenna. Maximum
performance is achieved when the antenna is aimed
toward the strongest signal source. If you know the
direction of your provider’s tower, point the antenna
in that direction. If you are unsure of the location, see
“Finding your closest cell tower” on page 9.
Step 1: Find area outside with strongest signal
Finding your strongest outside signal
Installation overview
To Next Page
