SurePrint SP91 - Page 34

SP91 User Manual
On 01 1 Character type B (9 × 17) 。
1 On D4 212 Set double width print
2 On D5 213 Cancel double width print
3
- - -- Undefined
- - -- Undefined
4
Off 0 0 Cancel double height mode
On 10 16 Set double height mode
5
Off 00 0 Cancel double width mode
On 20 32 Set double width mode
6 - - -- Undefined
7
- - -- Undefined
- - -- Undefined
[Particularize] · When selecting the double height and width mode at the same time, print 4 times
characters.
· The printer can add the underline to all characters, but can not add the
underline to blank and clockwise switching 90 which set by HT command.
· When the double or more height characters in one line, all characters will be
justified
along basis line.
· This command only effect for characters, Chinese invalid
[Default] n = 0
ESC
ESC
ESC
ESC $
$
$
$ nL
nL
nL
nL nH
nH
nH
nH
[Name] Set absolute print position
[Format] ASCII ESC $ nL nH
Hex 1B 24 nL nH
Decimal 27 36 nL nH
[Range] 0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
[Description] Set the distance from the beginning of one line to the position which will be printed the
characters.
The distance from the beginning of one line to the position which will be printed is:
[(nL + nH × 256) × 0.125 mm ].
Particularize] · The set which be appointed as the print area will be ignored.
In stable mode, use the horizontal motor unit (x).
[Reference] ESC
ESC
ESC
ESC \
\
\
\ , GS
GS
GS
GS $
$
$
$ , GS
GS
GS
GS \
\
\
\
ESC
ESC
ESC
ESC %
%
%
% n
n
n
n
Name] Select/cancel user-defined character set
[Format] ASCII ESC % n
Hex 1B 25 n
Decimal 27 37 n
[Range] 0 ≤ n ≤ 255
[Description] Select/cancel user-defined character set.
· When the LSB of n is 0, the user-defined character set is canceled.
· When the LSB of n is 1, the user-defined character set is selected.