SP91 User Manual
ple
dpi: per 25.4 mm {1 inch } print dot
· n is the quantity of NV bit image ( defined by ES q).
· m specify bit image mode
[Pa rticularize] · NV bit image defined bit image in NVM. Define by FS q, print by FS P.
· When the appointed NV bit image absent, this command is invalid.
· In stable mode, this command effects only when there are no data in buffer area.
· In page mode, this command is invalid.
· This command do not effected by print mode （ bold print ， overlap print ， underline
，
character size ， anti-white print or character 90 rotation etc. ）， except reversal print
mode.
· If set the NV bit image print area width which is less than a vertical line by GS L and
GS W, Executes the following operation only for problem line. In NV bit image mode,
a vertical line means the dot of normal mode ( m = 0, 48) and double height mode
( m = 2, 50) ， two dots of double width mode ( m = 1, 49) and quadruple mode
( m = 3, 51) .
① In NV bit image mode, the print area width extendes to right to a vertical line. In this
case, print can not over the print area.
②
If
the print area width can not extend to a vertical line, the left blank decreases to
contain a vertical line.
·
If
the download bit image overs one line, do not print the over data.
· In normal and double width mode, this command feed paper n dots, n is the height of
NV bit image, In double height and qu adruple mode, this command feed paper 2n
dots, n is NV bit image height, do not related with the line spacing which set by ESC 2
and ESC 3.
· After printing bit image, this command set the print position at the original of one line,
and deal with the continued data as normal data.
[Reference] ESC
ESC
ESC
ESC *
*
*
* , FS
FS
FS
FS q
q
q
q , GS
GS
GS
GS /
/
/
/ , GS
GS
GS
GS v
v
v
v 0
0
0
0
GS
GS
GS
GS
!
!
!
!
n
n
n
n
[Name] Select character size
[Format] ASCII GS ! n
Hex 1D 21 n
Decimal 29 33 n
[Range] 0 ≤ n ≤ 255
(1 ≤ vertical ≤ 8, 1 ≤ horizontal ≤ 8)
[Description] Set character height by 0-2, character width by 4-6. As follows:
To Next Page
Loading...