SurePrint SP91 - Chinese Character Control Command

SP91 User Manual
Xiyue Lotus Hill.
Far-ranging see stars.
Su hand hibiscus.
Step tread too pure virtual.
Colourful drag wide belt.
Fimbrist
##1D 28 6B 03 00 31 51 30##
5.5
5.5
5.5
5.5 Chinese
Chinese
Chinese
Chinese Character
Character
Character
Character Control
Control
Control
Control Command
Command
Command
Command
FS
FS
FS
FS !
!
!
! n
n
n
n
[Name] Set print mode for Chinese character
[Format] ASCII FS ! n
Hex 1C 21 n
Decimal 28 33 n
[Range] 0
≤
n
≤
255
[Description] Set print mode for Chinese character, set n as follows:
Bit Off/On Hex Decimal Function
0 - - - Undefined
1 - - - Undefined
2
Off 00 0
Disable double width
mode
On 04 4 Enable double width mode
3
Off 00 .
Disable double height
mode
On 08 8
Disable double height
mode
4 - - - Undefined
5 - - - Undefined
6 - - - Undefined
7 Off 00 0 Disable underline mode
On 08 128 Enable underline mode
[Particularize] · Set both double width mode and double height mode (contain right side and left side
character spacing), will print four times character size.
· The underline width specified by FS. It is not relevant to the character size.
· When some of characters in a line are double height or more times, all characters in
this line will adjust along the base line.
· Bold Chinese character by FS W or GS !, the last received set is effective.
[Default] n = 0
[Reference] FS
FS
FS
FS -
-
-
- , FS
FS
FS
FS W
W
W
W , GS
GS
GS
GS !
!
!
!