SurePrint SP91 - Page 68

To Next Page

To Previous Page

SP91 User Manual

steps: ：

1 ． Turn the power off, and pull the power cable and communication out.

2 ． Open the roll paper cover.

3 ． Clean cotton with a little alcohol, paint to surface dirt slightly, do not use sandpaper, blade or force materials to clean

print head slice! Or, the thermal print head slice will be damaged, and can not be recovered.

4 ． Clean the print head slice, after complete dry, do self test, watch the print result.

Note ： Never

Never

Never clean

clean

clean the

the

the print

print head

head

head slice

slice

slice when

when

when the

the

the thermal

thermal

thermal print

print head

head

head slice

slice

slice is

is heat,

heat,

heat, Or,

Or,

Or, it

it will

will

will cause

cause

cause head

head

head slice

slice

slice to

break.

APPENDIX

APPENDIX E:

E: CODE128

CODE128

CODE128 BAR

BAR

BAR CODE

CODE

E.1

E.1 CODE128

CODE128

CODE128 bar

bar

bar code

code

code description

description

In CODE128 bar code system, use one bar code character set, indicate 128 unit ASCII charactersand

2 bit data. These bar code characters specify 103 unit bar code characters and 3 unit code. Each

code indicates the following characters:

· Code set A: ASCII character from 00H to 5FH

· Code set B: ASCII character from 20H to 7FH

· Code set C: 2 bit natural digit character indicate by one character (100 unit natural digit from 00

to 99)

The following special characters in CODE128 ：

· SHIFT characters

Code set A ， the code follow with SHIFT will be processed as code B. Code B, the code followwith

SHIFT will be processed as code A. SHIFT characters can not be used in code C.

· Code set select character (CODE A, CODE B, CODE C)

The code set follow with this character turn to code AB or C.

· Function characters (FNC1, FNC2, FNC3, FNC4)

Function character depends on application software. FNC1 is valid in code C.

SurePrint SP91 - Page 68

Table of Contents