SurePrint SP91 - Page 67

SP91 User Manual
· Characters enlarges along the horizontal direction, characters enlarges to the right
side on basis of the left side.
· Select double width and double height mode, turn quadruple-size mode on/off by FS !
or GS !. The last received command set is effective.
[Default] n = 0
[Reference] FS
FS
FS
FS ！ ， GS
GS
GS
GS ！
APPENDIX
APPENDIX
APPENDIX
APPENDIX A:
A:
A:
A: MISCELLANEOUS
MISCELLANEOUS
MISCELLANEOUS
MISCELLANEOUS NOTES
NOTES
NOTES
NOTES
A.1
A.1
A.1
A.1 External
External
External
External Power
Power
Power
Power Connection
Connection
Connection
Connection Notes
Notes
Notes
Notes
· Connect the external power to the printer. and turn the power on when need. Be sure the
correct connection, if it is wrong, may be damage the external power or the printer.
· Over high voltage or low voltage occurred, turn the power off as soon as possible.
A.2
A.2
A.2
A.2 Another
Another
Another
Another Notes
Notes
Notes
Notes
 The printer operation
 When roll paper cover is closed, do not pull the roll paper.
 Thermal print head slice and driver IC are easy to damage, do not touch by
metal.
 In printing process or after using one period time, thermal print head slice
temperature turns to high, do not touch the print head slice.
 Do not use the roll paper cover usually when it is with roll paper.
 Do not touc the print head slice, dusty and other dirt materials with print head
cover that will damage the print head.
 Thermal roll paper contains Na+, K+, Cl- that will damage the thermal element
with thermal print head, so, please use the specified roll paper.
 Label paper can not be used.
APPENDIX
APPENDIX
APPENDIX
APPENDIX B:
B:
B:
B: ROLL
ROLL
ROLL
ROLL PAPER
PAPER
PAPER
PAPER SETUP
SETUP
SETUP
SETUP
B1Change
B1Change
B1Change
B1Change roll
roll
roll
roll paper
paper
paper
paper
1 、 Open the roll paper cover.
2 、 Put the new roll paper.
3 、 Pull one small part, and close the roll paper cover.
APPENDIX
APPENDIX
APPENDIX
APPENDIX C
C
C
C ：
：
：
： GET
GET
GET
GET RIGHT
RIGHT
RIGHT
RIGHT FROM
FROM
FROM
FROM AUTOCUTTER
AUTOCUTTER
AUTOCUTTER
AUTOCUTTER ERROR
ERROR
ERROR
ERROR
1. If the other materials, as clip, fall to autocutter and lock up autocutter, the printer turn to error status
and recover operation automatically .
2. If the problem is not serious, autocutter recovers to the normal position automatically. (Error LED flash continuely, but
error may be correct automatically.)
3. If autocutter does not return to the normal position, so run autocutter motor to return the origin
position.
APPENDIX
APPENDIX
APPENDIX
APPENDIX D:
D:
D:
D: CLEAN
CLEAN
CLEAN
CLEAN THE
THE
THE
THE PRINT
PRINT
PRINT
PRINT HEAD
HEAD
HEAD
HEAD
Roll paper slice fallen to the print head, it will cause print quality, clean the print head as the following