Sutter Instrument P-97 - Page 10

P-97 FLAMING/BROWN MICROPIPETTE PULLER OPERATION MANUAL – REV. 2.43 - DOM (20161118)
viii
Figure 2-2. P-97 Cabinet (end view, left), showing power switch. ...................................................... 10
Figure 2-3. Power connection..................................................................................................................10
Figure 3-1. Loading a piece of glass. ....................................................................................................... 11
Figure 3-2. Power-on display...................................................................................................................14
Figure 3-3. P-97 Program display. .......................................................................................................... 15
Figure 3-4. Clear Program Display......................................................................................................... 15
Figure 3-5. Access to control functions. .................................................................................................16
Figure 3-6. Write protection default state.............................................................................................. 20
Figure 3-7. Pull Cycle Report. ................................................................................................................. 20
Figure 3-8. Sample program....................................................................................................................21
Figure 3-9. Pull cycle report (multiple-loops).. ......................................................................................21
Figure 3-10. Side view of fire polishing spacer. .....................................................................................28
Figure 3-11. Fire Polish Spacer in Puller Bar. ...................................................................................... 29
Figure 3-12. Filament alignment. ........................................................................................................... 29
Figure 3-13. End view of box filament and glass................................................................................... 30
Figure 3-14. Box filament positioning. ................................................................................................... 31
Figure 3-15. End view of trough filament and glass............................................................................. 31
Figure 3-16. Trough filament positioning..............................................................................................32
Figure 4-1. V-Groove bearings and puller bars. .................................................................................... 33
Figure 4-2. Filament alignment. .............................................................................................................34
Figure 4-3. Micropipette shapes..............................................................................................................35
Figure 4-4. Pulley Adjustment. ............................................................................................................... 36
Figure 5-1. Power entry module. ............................................................................................................ 47
Figure 5-2. Fuse holder. ...........................................................................................................................48
TABLE OF TABLES
Table 3-1. Standard factory configuration.............................................................................................14
Table 3-2. Control Functions................................................................................................................... 17
Table 3-3. Maximum heat and recommended starting values for different filament shapes. .........18
Table 3-4. Box filament sizes...................................................................................................................31
Table 3-5. Trough filament sizes.............................................................................................................32