1A-116 Engine General Information and Diagnosis:
3 1) Turn the ignition switch OFF.
2) Check the continuity between Y wire and ground.
Special tool
(A): 09900–25008 (Multi circuit tester set)
EXCVA position sensor continuity
∞ Ω (Infinity)
3) If OK, then measure the EXCVA position sensor
resistance.
4) Connect the EXCVA coupler and set the EXCVA to
adjustment position. Refer to “EXCV Cable Removal and
Installation” in Section 1K (Page 1K-6).
5) Disconnect the EXCVA coupler and measure the
resistance between Y and W wires.
Special tool
(A): 09900–25008 (Multi circuit tester set)
Tester knob indication
Resistance (Ω)
EXCVA position sensor resistance at adjustment
position
Approx. 3.1 kΩ
((+) Y – (–) W)
Is the resistance OK?
Go to Step 4. Replace the EXCVA
with a new one.
Step Action Yes No
(A)
I947H1110094-01
(A)
I947H1110095-02
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
