Brake Control System and Diagnosis: 4A-7
6) Loosen the air bleeder valve and pump the brake
lever until the old brake fluid flows out of the brake
system.
7) Close the air bleeder valve and disconnect the clear
hose.
Tightening torque
Air bleeder valve (Front caliper): 7.5 N·m (0.75
kgf-m, 5.5 lbf-ft)
8) Fill the reservoir with brake fluid to the upper mark of
the reservoir.
9) Bleed air from the brake fluid circuit. Refer to “Air
Bleeding from Brake Fluid Circuit” (Page 4A-4).
10) Install the diaphragm and reservoir cap.
Rear Brake
1) Place the motorcycle on a level surface.
2) Remove the right side frame cover. Refer to “Exterior
Parts Removal and Installation” in Section 9D
(Page 9D-6).
3) Remove the rear brake fluid reservoir mounting bolt
(1).
4) Remove the brake fluid reservoir cap and
diaphragm.
5) Suck up the old brake fluid as much as possible.
6) Fill the reservoir with new brake fluid.
BF: Brake fluid (DOT 4)
7) Connect a clear hose to the air bleeder valve and
insert the other end of the hose into a receptacle.
I947H1410011-01
I947H1410012-02
I947H1410013-01
1
I947H1410050-01
I947H1410014-02
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
