1G-14 Fuel System:
Specifications
Service Data
B947H11707001
Injector + Fuel Pump + Fuel Pressure Regulator
Fuel
Tightening Torque Specifications
B947H11707002
NOTE
The specified tightening torque is described in the following.
“Fuel Pump Components” (Page 1G-10)
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List” in Section 0C
(Page 0C-9).
Item Specification Note
Injector resistance 11 – 13 Ω at 20 °C (68 °F)
Fuel pump discharge amount 222 ml (7.5/7.8 US/lmp oz) and more/10 sec.
Fuel pressure regulator operating
set pressure
Approx. 300 kPa (3.0 kgf/cm
2
, 43 psi)
Item Specification Note
Fuel type
Use only unleaded gasoline of at least 90 pump octane (R/2
+ M/2).
Gasoline containing MTBE (Methyl Tertiary Butyl Ether), less
than 10% ethanol, or less than 5% methanol with
appropriate cosolvents and corrosion inhibitor is permissible.
E-03, 14, 28, 33
Gasoline used should be graded 95 octane (Research
Method) or higher. Unleaded gasoline is recommended.
E-02, 19, 24, 51
Fuel tank capacity
Including
reserve
16.5 L (4.4/3.6 US/lmp gal) E-33
17.5 L (4.6/3.8 US/lmp gal) Others
Fuel level
indicator light
lighting
Approx. 3.5 L (0.9/0.8 US/lmp gal)
Fastening part
Tightening torque
Note
N⋅m kgf-m lbf-ft
Fuel pump mounting bolt 10 1.0 7.0 )(Page 1G-13)
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
