Charging System: 1J-5
5) Remove the gasket (3) and dowel pins.
6) Hold the generator rotor with the special tool and
remove the generator rotor bolt.
Special tool
(A): 09930–44530 (Rotor holder)
7) Screw in the special tool to the crankshaft.
8) Remove the generator rotor (4) using the special
tool.
Special tool
(B): 09930–30460 (Rotor remover bolt)
(C): 09930–34970 (Rotor remover)
9) Remove the generator stator (5).
Installation
Install the generator in the reverse order of removal. Pay
attention to the following points:
• Tighten the generator stator set bolts and generator
lead wire set bolt to the specified torque.
Tightening torque
Generator stator set bolt (a): 11 N·m (1.1 kgf-m,
8.0 lbf-ft)
Generator lead wire set bolt (b): 5.5 N·m (0.55 kgf-
m, 4.0 lbf-ft)
• Apply bond lightly to the generator lead wire grommet
(1).
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
3
I947H11A0007-01
(A)
I947H11A0008-01
(C)
4
(B)
I947H11A0009-03
(C)
(B)
I947H11A0022-02
5
I947H11A0010-01
(b)
(a)
1
I947H11A0011-03
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
