2B-9 Front Suspension:
16) Tighten the rod guide case to the specified torque.
Refer to “Rod Guide Case Tightening Torque”
(Page 2B-10).
Special tool
(B): 09940–84710 (Rod guide case wrench)
Tightening torque
Rod guide case: 90 N·m (9.0 kgf-m, 65.0 lbf-ft)
17) Pour specified fork oil up to the top of the rod guide
case.
: Fork Oil 99000–99001–SS5 (SUZUKI
FORK OIL SS-05 or equivalent)
18) Push the front fork cap, then stroke the outer tube
several times to pump out air.
NOTE
Take extreme attention to pump out the air
completely.
19) Hold the front fork vertically and adjust the oil level
using the special tool.
Special tool
(C): 09943–74111 (Front fork oil level
gauge)
Fork oil level “a”
75.0 mm (2.95 in)
20) Apply fork oil to the O-ring (13).
CAUTION
!
Use new O-ring to prevent oil leakage.
21) Tighten the front fork cap to the specified torque.
CAUTION
!
Do not clamp the outer tube too tight.
Tightening torque
Front fork cap: 35 N·m (3.5 kgf-m, 25.5 lbf-ft)
Special tool
(A): 09941–53670 (Front fork cap socket
wrench (45 mm))
(B)
I947H1220035-01
I947H1220036-01
I947H1220037-01
(C)
“a”
I947H1220038-01
(A)
13
I947H1220039-02
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
