Suzuki GSX-R1000 - Page 540

5B-8 Manual Transmission:
• Install the gearshift cam (2) with the bearing fitted.
• With engaging each fork end to the cam groove, insert
the fork shaft (3).
• Apply thread lock to the screws and tighten them to
the specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER “1322” or
equivalent)
Tightening torque
Gearshift cam bearing retainer screw (a): 10 N·m (
1.0 kgf-m, 7.0 lbf-ft)
Countershaft
• Install the C-ring (1) and bearing pin (2) to the upper
crankcase.
• Install the countershaft assembly to the upper
crankcase.
NOTE
Align the C-ring with the groove of bearing
and the bearing pin with the indent on the
bearing.
• Turn the bearing and set the bearing dowel pin in
position.
• Install the clutch push rod oil seal (3).
• Install the gearshift fork/gearshift shaft (4) and
gearshift shaft plug (5).
2
I947H1520047-01
3
(a)
I947H1520048-01
1
2
I947H1520049-01
I947H1520050-01
I947H1520051-01
3
5
4
I947H1520052-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk