6-5
NOTE: R = Replace, C = Clean, T = Tighten, I = Inspect and clean,
adjust lubricate or replace if necessary, L = Lubricate
* For each inspection or maintenance work, refer to the service man-
ual on the attached DVD. For each work procedure, refer to the cor-
responding page in the list in the Chapter “0B” in the service
manual.
Engine sprocket I – –
Check sprocket bolt for
looseness at each race
thereafter.
Rear sprocket I – –
Check and retighten
sprocket bolts at initial and
subsequent 10 minutes of
riding and each race
thereafter.
Drive chain buffer and guide – R –
Brakes ( 6-33) I – –
Replace brake hose and fluid
every year.
Front brake caliper axle bolt – T –
Front fork oil – R –
Change after 1st initial
break-in.
Front fork I – –
Check front fork inner tube
frequently for abnormality.
Check the air pressure.
Rear suspension I – –
Check rear suspension
system frequently and apply
the grease to the pivoting
portion as necessary.
Tire ( 6-39) I – –
Spoke nipple ( 6-41) I – –
Inspect every 20 min. up to
initial 2 hours then check
before each ride.
Steering I – –
Frame I – –
Swingarm I – –
Fuel tank I – –
Bolts and nuts T – – Retighten every 1 hour.
Lubrication ( 6-10) I I I
According to the schedule of
“Lubrication Points”.
Interval
races
Every
race
Every
3 races
Every
6 races
Remarks
Service Item
hours
Every
2 hours
Every
6 hours
Every
12 hours
To Next Page
Loading...
