6-6
ENGINE RUN TIME INDICATION
PROCEDURE
1. Disconnect the battery coupler
1 from the cap.
2. Connect a 12 volt battery to
the battery coupler using the
battery wire.
36890-28H00:
Battery wire (option)
3. After indicator light will be lit for
2 seconds (lamp check),
engine run time will be dis-
played by indicator light light-
ing time.
NOTE:
• Lighting of lamp check and
engine run time is made only
at the first time, and when
there is DTC available, this
DTC will be displayed repeat-
edly.
• Indicator light will be lit for 0.2
sec. per 1 hour of engine run
time.
• However, the display of engine
run time is limited to 100 hours
(lit for 20 sec.).
• Perform the same operation
when starting the engine.
To Next Page
Loading...
