Suzuki SV650A - Page 108

SV650K7/SK7/AK7/SAK7 (’07-MODEL) 107
Step 4
1) Measure the resistance between

5 terminal and ground at
the ABS control unit coupler.
$ Normal value: ∞ Ω (Infinity)
) Tester knob indication: Resistance (Ω)
Is the resistance between

5 and ground OK?
Step 5
1) Measure the resistance between

1 terminal and ground at
the front wheel speed sensor coupler.
$ Normal value: ∞ Ω (Infinity)
) Tester knob indication: Resistance (Ω)
Is the resistance between

1 and ground OK?
Step 6
1) Check for continuity between

F terminal on the ABS control
unit coupler and

2 terminal on the front wheel speed sensor
coupler.
$ Normal value: Continuity (*)
+ Tester knob indication: Continuity test (*)
Is there continuity between

F and

2?
Step 7
1) Check for continuity between

5 terminal on the ABS control
unit coupler and

1 terminal on the front wheel speed sensor
coupler.
$ Normal value: Continuity (*)
+ Tester knob indication: Continuity test (*)
Is there continuity between

5 and

1?
YES Go to step 6.
NO Go to step 5.
YES Inspect the wire harness. (Faulty B/R wire)
NO Faulty front wheel speed sensor
YES Go to step 7.
NO Inspect the wire harness. (Faulty W/R wire)
YES Go to step 8.
NO Inspect the wire harness. (Faulty B/R wire)
ABS control unit coupler
(Harness end)
Sensor side
ABS control unit coupler (Harness end)
Harness side
ABS control unit coupler (Harness end)
Harness side
SAMPLE