Suzuki SV650A - Periodic Maintenance Schedule

66 SV650K7/SK7/AK7/SAK7 (’07-MODEL)
IGNITION SYSTEM
INSPECTION
IGNITION COIL PRIMARY PEAK VOLTAGE
• Disconnect all the spark plug caps. (#Page 13)
• Connect new spark plugs to each spark plug cap and ground
them on the cylinder.
NOTE:
Be sure that all the spark plugs are connected properly and the
battery used is in fully-charged condition.
Measure ignition coil primary peak voltage (for #1 cylinder) in
the following procedure.
• Insert the needle pointed probe

A to the lead wire coupler (for
B/W wire).
%
" 09900-25009: Needle pointed probe set
• Connect the multi-circuit tester with the peak voltage adaptor
as follows.
Ignition coil (for #1cylinder):
B/W wire (

+ Probe) – Ground (

- Probe)
NOTE:
Do not disconnect the ignition coil primary lead wire.
" 09900-25008: Multi-circuit tester set
%
Use the special tool, to prevent the rubber of the water
proof coupler from damage.
Before using the multi-circuit tester and peak voltage
adaptor, refer to the appropriate instruction manual.
Peak volt adaptor
Ignition coil
ECM
Battery
New spark plugs
B/WW/Bl
SAMPLE