62 SV650K7/SK7/AK7/SAK7 (’07-MODEL)
THROTTLE VALVE SYNCHRONIZATION
USE OF SDS TOOL
Check and adjust the throttle valve synchronization between two
cylinders.
Step 1
• Lift and support the fuel tank with its prop stay.
(#SV650/SK3 5-6)
• Remove the rubber caps
1 from each vacuum nipple on the
throttle body.
• Connect the vacuum tester hoses
2 to each vacuum nipple.
Step 2
• Connect a tachometer.
• Set up the SDS tool. (#Page 94)
• Click “Data monitor”.
• Warm up the engine (Water temp. more than 80 °C (176 °F)).
SAMPLE
To Next Page
Loading...
