SV650K7/SK7/AK7/SAK7 (’07-MODEL) 95
USE OF SDS DIAGNOSIS RESET
PROCEDURE
• After repairing the trouble, turn OFF the ignition switch and
turn ON again.
• Click the ABS button
1.
• Click the “DTC inspection” button
2.
• Check the DTC.
• The previous malfunction history code (Past DTC) still
remains stored in the ABS HU. Therefore, erase the history
code memorized in the ABS HU using SDS tool.
NOTE:
The DTC is memorized in the ABS HU also when the wire cou-
pler of any sensor is disconnected. Therefore, when a wire cou-
pler has been disconnected at the time of diagnosis, erase the
stored malfunction history code using SDS.
• Click “Clear”
3 to delete history code (Past DTC).
SAMPLE
To Next Page
Loading...
